Menu
Yes, you can fit yourself in most cases.
Detailed DIY fitting instructions are supplied with every kit.
LOKKA can be installed by almost anyone with basic mechanical skill and tool kit .
LOKKA is designed to fit directly into the existing differential carrier as a replacement set of gears. Since the original hemisphere & carrier bearings are not replaced the ring & pinion gears do not have to be “set up”. Hence a Differential specialist is not specifically required.
However if you are unsure of your ability, using a professional is a good idea.
This depends very much on the model, who is doing the job and the facilities at hand.
As a guide you could expect 1-3 hours for many rear fittings, most front fittings are around 3-4 hours. IFS vehicles can take from 3-5 hours.
No. Any recommended differential oil is OK to use including LSD oil and differential additives such as teflon treatments etc.
No. LOKKA fits inside the carrier and does not affect the ring and pinion gears which determine the differential ratio.
LOKKA design uses a large number of very low profile teeth which collectively do all the ramping and the driving. Engine power is transferred through the flats of all 20 teeth at the same time rather than the original standard differential which has only 2 or 4 teeth driving at a time, with all the force being transmitted between two points on the involute curved surfaces of the pinion and side gear teeth.
LOKKA has a total linear length of approx. 4.7″ (12cm) and surface area of around 1.2″2(3cm2) and hence has 2-5 times greater surface area over which to transfer the engine power. This means that LOKKA can handle substantially more power than the original differential gears.
LOKKA is made from a tough heat treated steel alloy.
LOKKA design is by sight extremely simple – in fact so simple that many people cannot understand how it can operate so well. However this belies the sophistication of its Patented design.
LOKKA, due to its design and material composition, has a life expectancy approximately twice as long as the traditional differential – this is obviously dependent on the use and application, fitment, condition of differential etc.
LOKKA enjoys an excellent reputation for reliability and durability. It has a 3 Year Limited International Warranty.
There is an extensive range of LOKKA models that is continually expanding to suit new and older 4WD’s.
Can be fitted in 4×4, 2×4, SUV’s, campers, civilian, commercial, performance – off-road racing, drifting, hill climb etc.
LOKKA cannot be used on-road in the front axles of constant four wheel drive vehicles that do not have a Part Time 4WD transmission option.
For some Full Time 4×4 vehicles, a Part Time Conversion Kit is available.
LOKKA only fits into normal standard differential hemispheres. Exception: there is a range of models designed to fit into many Toyota factory LSD centres.
This is dependent on the vehicle, its existing differential types, the type of suspension system, LOKKA model availability and the type of 4×4 driving you do.
However, often the front is the first choice.
* Q10 d. – Extra info
A couple of things to Note: the front diff lock (any type) will give the greatest advantage off road, rather than the rear, assuming most vehicles have greater problems going up hill rather than down.
Two are better than one, but one in the front is better than one in the rear.
This is due in part to the transfer of weight onto the rear wheels, thereby providing greater ‘natural’ traction as the weight pushes the rear wheels into the terrain. The steeper the slope, the greater the weight transfer.
In addition the front wheels usually have less wheel travel than the rears, so they tend to lift off the ground as the rear drops into holes. As soon as they do, the drive load is rapidly doubled on the rear wheels, as all the front drive is lost to the wheel spinning in the air or on the loose surface, and the front wheel still on hard ground has no drive.
All the load of moving the vehicle is on the rear wheels. The rapid transfer of this load encourages the rear wheels to break traction – forward motion is stopped.
Also remember the front wheels get to the worst part of the track first – assuming you are going forward. The loose gravel, the sandy bit, the tree root, rock ledge, the slippery mud etc etc all these will get one front wheel spinning first, then the other front wheel not being driven, the load on the rear wheels rapidly doubles. The resulting rapid transfer of load encourages the rear to break traction again – forward motion is stopped.
Putting any locker into the rear does nothing to stop the front losing traction, it just makes the vehicle a lot better 2×4, better at pushing from the rear. Even if you can only keep one wheel driving at the front, you will probably have three wheels working and spreading the driving load over the greater surface area of three tires.
This is a matter of money and requirement.
A single LOKKA will substantially improve a vehicle’s off-road ability. This is easily tested by taking a LOKKA equipped vehicle up a steep hill or across terrain that has previously been impossible to traverse and drive it at a lower speed beyond that same spot, even to the point of stopping and restarting from that same spot.
Dual LOKKAs gives a vehicle even more capability at lower speeds.
If a vehicle has adequate traction it may not require large amounts of momentum, thus a Dual LOKKA equipped vehicle will be able to negotiate difficult obstacles that were previously only possible with the use of high speed and momentum. By eliminating speed from your obstacle negotiation you will have minimised potential for loss of control and damage.
In some cases, providing you are keeping the same brand or model of vehicle or have the same differential. Every LOKKA model has been designed to fit a particular differential, so you will need to check for differential compatibilities.
LOKKA’s design is actually as an automatic “UN-locker” ie. it is normally locked and automatically unlocks when differential action is required. ie. the outside wheel in the corner “overruns” the speed of the inside wheel. There are no switches, electrical, pneumatic or external connections required.
Yes. LOKKA is positive locking, meaning there is no slippage when locked – there is a mechanically solid engagement of all parts. This means that you get 100% of drive and traction to both wheels.
The real question is “I don’t understand how it can unlock when you go around a corner but doesn’t unlock when there is a loss of traction”.
The answer is two fold:
Firstly: LOKKA is normally locked and only unlocks when something (other than the engine) forces a wheel to turn faster than the differential is turning it. (ie. to overrun). So when one wheel is in the air it just stays locked
Secondly: because LOKKA is normally locked, unlike a standard differential it can never break traction on only one wheel. It is physically impossible to drive one wheel faster than another by the engine – the two wheels will always be driven at the same speed, ie. a wheel can turn faster than the differential turns it, but it can never turn slower.
Thus, the only time that a wheel can turn faster than the differential or engine is turning it, is when you go around a corner and the “ground driven” forces (momentum & traction) acting on the outside wheel (which has the greater distance to travel) force it to turn faster and LOKKA automatically unlocks.
This is the hardest question of all. Read “How it Works” section
Yes, it will effect your steering, but not normally in an adverse manner.
It is recommended that you become familiar with the changes before attempting any 4×4 use.
Unlike manual lockers which do not provide differential action when locked, LOKKA’s operation allows differential action, resulting in almost un-compromised steering irrespective of uphill or downhill, soft or hard surfaces. This means you can select the best path and negotiate tight bends. You will feel a mild tightening in the steering wheel which is a result of having both front wheels biting into the terrain, driving more equally.
There are situations where steering and handling will change including some understeer and more self-centering of the steering wheel.
The use of twin locking differentials can cause inter axle windup and this can affect steering to a greater extent – stronger self-centering, greater understeer and larger turning circles.
Yes. LOKKA is completely symmetrical in its design and operates going forward & reverse, up & down hill.
With a standard differential it is possible to lock up a single wheel while braking and loose steering and traction. The wheel on the more slippery side locks up first and the other wheel, due to normal differential action, speeds up (ie 0:100 power split ratio).
Since this accelerated wheel is actually the wheel which is on firmer ground the increase in its speed acts to accelerate the vehicle even faster down the slope!
LOKKA will ensure that both wheels under the effect of engine braking will remain locked and hence provides improved downhill braking.
Automatic lockers often make some degree of noise. If LOKKA is operating normally, it is possible to hear a light clicking sound when cornering. However, this is often inaudible from inside the cabin, especially with either the radio on or windows closed.
Vehicles with manual transmission may experience some extra drive-line ‘back-lash’ as well as other noises intermittently. These are typical of automatic lockers. Smooth application of power and a more careful driving style will minimise their occurrence but not eliminate it.
Uneven tire pressures and uneven tire size will make all noises and ‘back-lash’ more predominant. It is important for on-road safety and off-road capability that tires be evenly inflated and evently sized.
Note: Even new tires can vary in size and may need to be matched.
LOKKA should actually prolong the life of a differential due to the sharing of normal off-road terrain driving loads more evenly between the axles. The locking action prevents one wheel spin up (and resultant damage that can occur when a spinning wheel obtains sudden traction), however in certain difficult situations (refer to Q21 for situations) greater stresses can occur.
Yes it could in certain circumstances.
Never drive your 4×4 on a hard surface with either the hubs locked or in 4×4. It will result in erratic steering, severe transmission wind-up resulting in unsafe driving and potential drive-line damage.
With LOKKA fitted, single wheel ‘spin-up’ can never occur – it is not physically possible to drive one wheel faster than the other – thus with two wheels driving at the same speed, the sudden stress loading of drive-line components which occurs when a spinning wheel suddenly grips and stops is alleviated.
However, even though you will be able to negotiate more difficult obstacles more slowly, with greater control, with better path selection and with less bouncing around, you will now be able to take your vehicle to places that it could never go before and some driving care will be required to avoid overloading drive-line components resulting in failure – particularly in more difficult and remote terrain.
In the case of a vehicle with dual locked differentials, there is more acute inter-axle wind-up, which creates stronger forces on drive-line components, particularly on hard surfaces where there is no tire slippage.
The driver should take these extra forces into consideration to avoid resulting drive-line failure and vehicle damage.
LOKKA has been manufactured in Australia since the late 1990’s and has been sold globally under its own brand name or re-branded for local resellers.
From 2003 to 2012 it was best known in North America under the brand name Aussie Locker™*
The Aussie Locker™ model listing was only a small subset of the total number of products that were available.
Gear to Goannawhere is very pleased to offer the entire product range without limitation (to suit USA, Asian & European models) and with a 3 Year Limited International Warranty.
All development and manufacturing design of the key components has always been performed in Australia.
To ensure the highest product quality, all Designs, Manufacturing techniques and international Patents are proprietary and have never been externally licensed to third parties.
Any representations to the contrary are false.
LOKKA enjoys an excellent reputation for reliability throughout the world – sold in every continent, in all realms of 4×4 and 2×4 performance activity.
